SuzukiSavage.com - Thumb/cable decompression lever?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Thumb/cable decompression lever?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

Thumb/cable decompression lever? (Read 225 times)

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Thumb/cable decompression lever? Reply #15 - 09/21/16 at 12:49:03 Which is how Dave described doing it.
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

Dave

YaBB Moderator
ModSquad

Offline

SuzukiSavage.com
Rocks!

Posts: 18099
Camp Springs, Kentucky
Gender: male

Re: Thumb/cable decompression lever?
Reply #16 - 09/21/16 at 13:41:59

justin_o_guy2 wrote on 09/21/16 at 12:49:03:

Which is how Dave described doing it.

No...one hole and then file. The rounded ends of the curve are not complete circles.

The decompression shaft was round, and then then they machined two flat spots. The hole in the lever has to match that, as shown by the shaded section below. I drill one hole, then begin filing.,....if I try drilling 2 smaller holes, I always end up screwing the thing up when the drill bit intersects the edge of the first hole and the drill snags. In this thin sheet metal the Uni-bit stepped drills don't catch and deform the piece.

DecompCam.jpg

Someday I will be old......But not today!

IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Thumb/cable decompression lever? Reply #17 - 09/21/16 at 13:44:56 Well, now That's cleared up.
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: Thumb/cable decompression lever? Reply #18 - 09/21/16 at 13:57:04 Just drill a hole, grab a hammer and pound on it till it fits. Then grab your welder and make it permanent. case closed, finito, al fin.
Back to top	Versey's Place Tech Section Index IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home