SuzukiSavage.com - frame swap

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › frame swap

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

frame swap (Read 259 times)

Ruttly Serious Thumper Offline Thumpers Rule Posts: 5107 Manteca , CA Gender:	Re: frame swap Reply #15 - 09/17/16 at 14:27:32 Check voltage going into and coming out of ignition switch , make sure switch is in on position not park, if tank is off use a jumper wire at ignition switch plug on harness side for the 2 wires shown in diagram, if ground at battery and frame are good you should have at least a neutral light if trans is in neutral
Back to top	The Topic Terminator IP Logged

Ruttly Serious Thumper Offline Thumpers Rule Posts: 5107 Manteca , CA Gender:	Re: frame swap Reply #16 - 09/17/16 at 14:49:48 If still no power install a bypass at side stand switch , let me know
Back to top	The Topic Terminator IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: frame swap Reply #17 - 09/17/16 at 15:16:50 You have 12 volts into the switch. You flip it on. The wire coming out has 12 volts Where does that stop being true? Or Turn it on And you have 12 volts on no 12 volts out equals bad switch
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

rbeathe YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 19	Re: frame swap Reply #18 - 09/17/16 at 15:47:32 battery is 12.5, fuses 12.3 (both sides), we are good to the switch like I said its after the switch
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: frame swap Reply #19 - 09/17/16 at 16:29:54 sounds like you gotta dead short. pull the fuses and replace with a lamp. turn on the key so the lamp lights. then start pulling connectors one by one till the lamp goes out. if the lamp doesn't go out then it's the harness. also check your wiring, most connectors will have the same colors on both sides.
Back to top	Versey's Place Tech Section Index IP Logged

rbeathe YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 19	Re: frame swap Reply #20 - 09/17/16 at 20:35:53 Tank is off but instrument cluster is plugged in. All connectors are paired up correctly. I have pwr to the IG but when I turn the switch on it goes away so the open is past the IG correct?
Back to top	IP Logged

rbeathe YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 19	Re: frame swap Reply #21 - 09/17/16 at 20:39:17 ..also that would not allow me to put a pwr lamp at the fuse box because as soon as I close IG to 'on' I open the circuit and lose my pwr.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: frame swap Reply #22 - 09/17/16 at 20:53:24 rbeathe wrote on 09/17/16 at 20:35:53: I have pwr to the IG but when I turn the switch on it goes away How can it go away w/out flame and smoke?
Back to top	Versey's Place Tech Section Index IP Logged

rbeathe YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 19	Re: frame swap Reply #23 - 09/18/16 at 06:13:06 It goes away if there is an open in the circuit past the switch.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: frame swap Reply #24 - 09/18/16 at 07:49:05 what battery do you got?
Back to top	Versey's Place Tech Section Index IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: frame swap Reply #25 - 09/18/16 at 09:38:01 If you're finding power into the switch, but not out of the switch, it's the switch.
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

batman

Serious Thumper

Offline

SuzukiSavage.com
Rocks!

Posts: 3806
osceola new york
Gender: male

Re: frame swap
Reply #26 - 09/18/16 at 15:22:18

A battery coming off full charge should have a voltage more in the 13-13.5 area as the charger voltage needs to be higher to push juice into the battery. why don't you try jumping the bike off a car battery (car NOT running) ,you might try unplugging your head light also as it is a major draw(55watts/12v=4amps) If you then get the neutral light to turn on(3watts) you'll know your battery is bad or you can Jump it or take the battery somewhere to be load tested.

my old work mates called me MacGyver

IP Logged

BSTON Full Member Offline Posts: 218 Milwaukee, WI	Re: frame swap Reply #27 - 09/20/16 at 12:48:08 When I was doing my Ryca there were two 2-wire connectors that were the same size that fit together. I can't remember what they were for though. Looking at the wiring diagram that I have, the sidestand switch, pickup coil, and decomp solenoid are all 2 wire connectors. Maybe one of them got switched?
Back to top	1996-03WiringDiagpg2.jpg IP Logged

BSTON Full Member Offline Posts: 218 Milwaukee, WI	Re: frame swap Reply #28 - 09/20/16 at 12:58:51 I was just thinking about it a little more. at the time that I would have been hooking up electrical connections, my sidestand switch connector would have been removed. That just leaves decomp and pickup coil.
Back to top	IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home