Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
Rubber Side Down!
› TM40 pumper carb from Pro Cycle
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages: 1
TM40 pumper carb from Pro Cycle (Read 140 times)
SinglesGoinSteady
Full Member
Offline
SuzukiSavage.com
Rocks like Bon
Scott!
Posts: 130
From Seattle, now in Savannah.
Gender:
TM40 pumper carb from Pro Cycle
08/19/16 at 15:53:59
It's on, and works like a champ. It's the full Mikuni TM40 kit for the DR650. The kit is bone stock, meaning I slapped it on and it went like dynamite. It just barely fits under the Ryca tank and CS-1 kiit I have going. Of note, I have 7/8" bars with a throttle and tube from a 1996 DR650. Those mate directly to the cables in the Pro Cycle kit. I already had a rubber carb to head boot that fits also. I still have the stock RH side switch gear until I get a new mini switch installed. I also have an open tube intake with a Uni double filter on it and an open exhaust with a Supertrapp and about 10 discs going. It's 90 degrees here at sea level and fired right up. Have yet to check the plug, but, the performance is a real kick. Instant throttle and power, like riding a fly by wire FZ09 (minus 75% power haha). Awesome mod, cannot recommend it enough. Instant response at any range and speed.
Back to top
2016-08-19_18_56_09.png
http://rycatracker.blogspot.com/
IP Logged
Kris01
Serious Thumper
Offline
Eat, sleep, RIDE!
Posts: 3767
Tennessee
Gender:
Re: TM40 pumper carb from Pro Cycle
Reply #1 -
08/19/16 at 17:15:24
More details on your carb
and starter
please!
Back to top
There's no problem that a full tank of gas and a sunny day can't fix!
2008 S40, Rotella T 15W-40 w/ZDDP added, Dyna, 140/90-15, Battery Tender Jr., Seat lift, #52.5/150/3 washers, Raptor
IP Logged
SinglesGoinSteady
Full Member
Offline
SuzukiSavage.com
Rocks like Bon
Scott!
Posts: 130
From Seattle, now in Savannah.
Gender:
Re: TM40 pumper carb from Pro Cycle
Reply #2 -
08/19/16 at 17:45:23
Starter cover is just an old Bud can trimmed to fit over the starter. Tab top
. The Mikuni is a TM40 flat slid with a pumper nozzle to inject fuEl to the needle we the throttle is turned. I got the $520 kit from Pro Cycle, it's a bolt on for the DR650. Came with 2 extra pilots and mains either side, the cables and instructions. Not cheap, but, all done for ya. I'll fine tune the jetting soon. I'll post what jets it has tomorrow. Worked amazingly well out of the box considering it's for a slightly higher compression motor with unknown mods.
Back to top
http://rycatracker.blogspot.com/
IP Logged
SinglesGoinSteady
Full Member
Offline
SuzukiSavage.com
Rocks like Bon
Scott!
Posts: 130
From Seattle, now in Savannah.
Gender:
Re: TM40 pumper carb from Pro Cycle
Reply #3 -
08/24/16 at 06:11:08
Currently the setup is 150 main jet and 22.5 pilot. I feel it's not as instantaneous a it should be off idle, so I'm going to look at the needle jet, needle height and accelerator pump. It packs a big wallop off idle or any time you whack it, no mistake about that!
Back to top
http://rycatracker.blogspot.com/
IP Logged
Ruttly
Serious Thumper
Offline
Thumpers Rule
Posts: 5112
Manteca , CA
Gender:
Re: TM40 pumper carb from Pro Cycle
Reply #4 -
08/24/16 at 21:09:06
Any other engine mods besides the muffler ?
Back to top
The Topic Terminator
IP Logged
SinglesGoinSteady
Full Member
Offline
SuzukiSavage.com
Rocks like Bon
Scott!
Posts: 130
From Seattle, now in Savannah.
Gender:
Re: TM40 pumper carb from Pro Cycle
Reply #5 -
08/26/16 at 21:17:57
Uni filter intake. It's got high flow for sure. Still working on the jetting. I'll post a pic soon of intake.
Back to top
http://rycatracker.blogspot.com/
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
»» Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
- The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
09/30/24 at 21:15:34
›
General Category
›
Rubber Side Down!
› TM40 pumper carb from Pro Cycle
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.