Blade
Full Member
Offline
Posts: 135
Sydney Australia
Gender:
|
I purchased this tail light as it has an E mark, which can be important here. When I first installed it, it was so deep front to back, that it was at risk of being caught by the tyre on a pothole, and that would drag the light back under the fender.
So ... I decide to do a little modification. I trimmed the light down to less than half using a dremmel on all parts. It's not a solution I would recommend to take on, but once I started it I had to see it through to the end. If you can find a thin taillight to start with, go with that.
The mounting method is by an aluminium bracket slid between the fender and mounting plate, then secured with a wide headed (red) bolt through the fender. I will have a bib and rack on top to cover any remaining bolt holes.
|