SuzukiSavage.com - what is the best way to clean rust out of a tank

nchristian YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 9	what is the best way to clean rust out of a tank 08/06/15 at 13:07:23 So my 87 savage with 13,000 miles on it has been acting up lately. I've come to the decision to buy a new petcock and clean the rusty tanks. What is the best way I can go about doing this?
Back to top	IP Logged

1st2know

Senior Member

Offline

Currently between
Savages

Posts: 295
Seattle, WA
Gender: male

Re: what is the best way to clean rust out of a ta
Reply #1 - 08/06/15 at 17:51:49

I used aquarium gravel with distilled water.

All of my rust was up top, from what I could tell. The bike had been sitting wet for over three years with just over reserve.

I took off the petcock, speedo and gas cap. I taped up the petcock hole with masking tape. Poured about 1 1/2 cups of gravel in the tank, and a gallon of water.

I swirled that around in the tank for about 20 minutes.
Emptied the tank in to a bucket, then rinsed and rinsed.

Once I was convinced I got all the gravel(and sand) out, used compressed air to chase out as much moisture as I could.

I let it dry over night. Put it back together and filled it with gas.

Back to top

Kaw VN1700, V-Strom 650, Coal powered Chevy Spark.

IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18099 Camp Springs, Kentucky Gender:	Re: what is the best way to clean rust out of a ta Reply #2 - 08/06/15 at 19:02:43 This is how I do it. http://suzukisavage.com/cgi-bin/YaBB.pl?num=1386849349
Back to top	Someday I will be old......But not today! IP Logged

justin_o_guy2

Serious Thumper

Offline

What happened?

Posts: 55279
East Texas, 1/2 dallas/la.

Re: what is the best way to clean rust out of a ta
Reply #3 - 08/06/15 at 20:59:25

If it's just kinda stained, no flakes, Ospho will turn it from iron oxide to iron phosphate. Very low hassle, ten dollars,
Liquid, not gel. Sherwin Williams, Kelly Moore, dilute phosphoric acid.
I think it's got a different name now, but I keep a quart in the shop at all times. Like Brylcreme, a little dab'll do ya,,,

Back to top

The people never give up their liberties but under some delusion.- Edmund Burke.

IP Logged

Kris01 Serious Thumper Offline Eat, sleep, RIDE! Posts: 3767 Tennessee Gender:	Re: what is the best way to clean rust out of a ta Reply #4 - 08/06/15 at 21:24:13 Naval Jelly is phosphoric acid. Great stuff for rust. You can't let it dry though.
Back to top	There's no problem that a full tank of gas and a sunny day can't fix! 2008 S40, Rotella T 15W-40 w/ZDDP added, Dyna, 140/90-15, Battery Tender Jr., Seat lift, #52.5/150/3 washers, Raptor IP Logged

Kris01 Serious Thumper Offline Eat, sleep, RIDE! Posts: 3767 Tennessee Gender:	Re: what is the best way to clean rust out of a ta Reply #5 - 08/06/15 at 21:26:12 I've heard of people putting sheetrock screws in their tank and wrapping it in blankets. Throw it in the dryer (no heat!) and let it tumble for a while.
Back to top	There's no problem that a full tank of gas and a sunny day can't fix! 2008 S40, Rotella T 15W-40 w/ZDDP added, Dyna, 140/90-15, Battery Tender Jr., Seat lift, #52.5/150/3 washers, Raptor IP Logged

NCSUindy09

Junior Member

Offline

Rollin'

Posts: 64

Re: what is the best way to clean rust out of a ta
Reply #6 - 08/07/15 at 09:27:12

I used a nice heavy chain and some gasoline and shook it. Just make sure you have a tool around that can reach the chain to pull it out. It'll also be a tangled mess. Coat it with something if you're trying to never deal with all that again.

I installed an in-line fuel filter and that has solved all my dirty carb and stuck float problems. Plus the chrome on the filter is shinier than any other part on my bike... Grin

Back to top

1986 Savage, 18k Miles. Cone air filter, drilled & wrapped exhaust. Stock carb and jets. Daily commute bike.

IP Logged

Kris01 Serious Thumper Offline Eat, sleep, RIDE! Posts: 3767 Tennessee Gender:	Re: what is the best way to clean rust out of a ta Reply #7 - 08/07/15 at 11:10:27 Just FYI, some people have reported fuel flow problems with using a fuel filter. It restricts flow too much.
Back to top	There's no problem that a full tank of gas and a sunny day can't fix! 2008 S40, Rotella T 15W-40 w/ZDDP added, Dyna, 140/90-15, Battery Tender Jr., Seat lift, #52.5/150/3 washers, Raptor IP Logged

nchristian YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 9	Re: what is the best way to clean rust out of a ta Reply #8 - 08/10/15 at 08:12:38 where can i find that in line fuel filter. Also there are a lot of flakes i hear at the bottom when the tank is empty what should i use
Back to top	IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18099 Camp Springs, Kentucky Gender:	Re: what is the best way to clean rust out of a ta Reply #9 - 08/10/15 at 08:42:14 nchristian wrote on 08/10/15 at 08:12:38: where can i find that in line fuel filter. Also there are a lot of flakes i hear at the bottom when the tank is empty what should i use http://suzukisavage.com/cgi-bin/YaBB.pl?num=1386849349 http://suzukisavage.com/cgi-bin/YaBB.pl?num=1211846392
Back to top	Someday I will be old......But not today! IP Logged

MnSpring

Serious Thumper

Offline

Younger than most
people my age.

Posts: 9345
Minn
Gender: male

Re: what is the best way to clean rust out of a ta
Reply #10 - 08/10/15 at 18:05:09

In small metal, really rusty, gas tanks.
Success comes from, taking out/off the parts connected.
Filling the tank, with about 1/4, ‘Crushed Walnut hulls’,
(Go to a pet-mart, look at, ‘Reptile’ bedding’.)
Or a clean, ’sand’, with about 1/2 water, and just a 1/4 oz of any soap, dish-washing soap.
Or MANY, of the fancy, ceramic rods, but only if you have them,
(do NOT got out and buy them for the one thing)

Seal up the tank, Wrap in Blankets, secure in a elect Cement Mixer,
(Or cloths Dryer)
And let it tumble. The longer the better.
May take a day, or a hour.
The point is, the, ’Tank’, is secure, the stuff inside moves around to all parts of inside the tank.

Now, clean, then clean again, then clean again, then dry.

The inside may be, ’Shiny’, or may be, just a Little stained.
(Depends on what you used, and the time)

Now use it, the teeny tinny, pieces of rust, most likely, will just run right through.
Or put a, ‘filter’ on, just for a, ’Belt & Suspenders’

That’s the cheep way.

The fancy, way, Spend Lots of Money !

Back to top

Ben Franklin once said: "If you give up a freedom, for the sake of security, you will have neither".
Which is More TRUE, today, than yesterday.('06, S-40, Stock) well, mostly .

IP Logged