jwenrich
YaBB Newbies
Offline
SuzukiSavage.com Rocks!
Posts: 49
|
Ok coming back to this thread. Figured all the info was here already. Bike has been running alright, except I blew out the sealant I used at the muffler tip, where the baffle doesn't seal along the outside edge.
Is instant weld sealant a good thing to use? The silicone stuff doesn't seem to work well in a dynamic environment.
So my Jetting. It runs, but I think its rich. Any choke kills it almost instantly, and the mixture screw makes no difference when screwed all the way in. Also the tinging noise is still present, but only on start up when cold. Goes away fairly quick (2-3 minutes). Appears to be coming from the header/cylinder maybe?
Well I put the stock pilot back in and it idled really bad. The tinging got way worse, and I had to turn the idle screw up higher. But when I turned in the mixture screw all the way, it ran slightly better.
So it runs fine richer with the 55 pilot, but badly with the 52.5, but then slightly better leaning out the mixture screw. This seems odd.
I may have made a mistake with my needle though. I sanded down the tapered tip slightly, and the spacer as well, so it is now just over 2/3rds original thickness. Does the needle affect the entire circuit, down to idle?
Thanks for any input.
|