SuzukiSavage.com - tiny brass rod

Donate!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › tiny brass rod

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

tiny brass rod (Read 58 times)

zipidachimp Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1416 surrey, b.c. Gender:	tiny brass rod 03/31/15 at 12:08:31 After installing my verslagy, I noticed a tiny brass rod sticking out of the crankcase above the clutch pack and below the speedo connection, right next to the gasket. ??? Also, with the verslagy in the new hole, chain slack is minimal/tight. Any problems here?
Back to top	IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18099 Camp Springs, Kentucky Gender:	Re: tiny brass rod Reply #1 - 03/31/15 at 12:36:50 I believe you are talking about a piece that is a metering device for the flow to top end....the oil that goes up to the camshaft and rockers. It is located in that section of gasket at the top that has a double wall passage. (You aren't talking about any loose parts are you?)
Back to top	Someday I will be old......But not today! IP Logged

zipidachimp Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1416 surrey, b.c. Gender:	Re: tiny brass rod Reply #2 - 03/31/15 at 13:34:32 no loose parts, hard to see, but looks like a tiny hole in the side. don't see it mentioned anywhere on forums. caught me by surprise.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: tiny brass rod Reply #3 - 03/31/15 at 13:44:22 I think that's the cross over to the clutch pack bearings. you won't have any problems if you leave it alone like most people. if you let the spring take out the slack, no problem. if you forced it by means other than your bare hand, push in the pawl and let the tension off.
Back to top	Versey's Place Tech Section Index IP Logged

zipidachimp Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1416 surrey, b.c. Gender:	Re: tiny brass rod Reply #4 - 03/31/15 at 14:21:43 just yanked out the folded tye-rap. not much slack in the chain now.
Back to top	IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: tiny brass rod Reply #5 - 03/31/15 at 14:36:22 zipidachimp wrote on 03/31/15 at 14:21:43: just yanked out the folded tye-rap. not much slack in the chain now.
Back to top	Versey's Place Tech Section Index IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

« Home