SuzukiSavage.com - Wont rev up after Raptor petcock change

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Wont rev up after Raptor petcock change

(Moderators: verslagen1, Dave, Serowbot)

Pages: 1

Wont rev up after Raptor petcock change (Read 148 times)

hairball YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 1	Wont rev up after Raptor petcock change 03/23/15 at 11:22:40 I need a bit of advice or help here, I changed out the old petcock for a raptor petcock and can start bike but choke has to be all the way out and it will just idle and that's all, when I rev up the engine it dies. any suggestions? its a boulevard s40 650 and its a 2006 but I have less than 3k miles on it.
Back to top	IP Logged

Dave YaBB Moderator ModSquad Offline SuzukiSavage.com Rocks! Posts: 18098 Camp Springs, Kentucky Gender:	Re: Wont rev up after Raptor petcock change Reply #1 - 03/23/15 at 11:28:47 Did you put a rubber cap over the vacuum nipple on the carb body.....or plug the vacuum hose? If not....it is causing an air leak.
Back to top	Someday I will be old......But not today! IP Logged

hotprops Full Member Offline SuzukiSavage.com Rocks! Posts: 180 fort myers fl	Re: Wont rev up after Raptor petcock change Reply #2 - 03/23/15 at 13:33:27 sounds like lack of fuel flow.Did you buy the real real Suzuki part or a knockoff? there was a thread that addressed this and went so far as to specify correct fuel flow in cups per minute . ma by someone can find it and provide linkage . and yes you plugged the vacuum inlet on the carb right?
Back to top	IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Wont rev up after Raptor petcock change Reply #3 - 03/23/15 at 18:10:01 How much did you pay for the Raptor?
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

T.Claiborne13 YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 48	Re: Wont rev up after Raptor petcock change Reply #4 - 03/27/15 at 16:54:17 on a side note would the vacuum line being left open(not plugged) cause it not to start as well?
Back to top	IP Logged

Serowbot YaBB Moderator ModSquad Online OK.... so what's the speed of dark? Posts: 28645 Tucson Az Gender:	Re: Wont rev up after Raptor petcock change Reply #5 - 03/27/15 at 18:07:04 T.Claiborne13 wrote on 03/27/15 at 16:54:17: on a side note would the vacuum line being left open(not plugged) cause it not to start as well? It could... leaving the vacuum tap unblocked creates a giant vacuum leak... With no vacuum the engine has a hard time drawing in fuel... No fuel,.. no go... ...
Back to top	Ludicrous Speed !... ... ... IP Logged

T.Claiborne13 YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 48	Re: Wont rev up after Raptor petcock change Reply #6 - 03/27/15 at 18:43:47 ok I did the raptor switch and forgot about that until I saw this thread
Back to top	IP Logged

Serowbot YaBB Moderator ModSquad Online OK.... so what's the speed of dark? Posts: 28645 Tucson Az Gender:	Re: Wont rev up after Raptor petcock change Reply #7 - 03/27/15 at 22:38:52 It's very important to block that vac tap... It's not a flaw in the Raptor conversion,... a leak is just as likely in the stock vacuum hose... That tap being open, is like drilling a 1/4" hole in your intake manifold...
Back to top	Ludicrous Speed !... ... ... IP Logged

farmerpete YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 4	Re: Wont rev up after Raptor petcock change Reply #8 - 03/28/15 at 18:53:11 Just a side note.. I swapped my petcock for a Raptor recently, and now it runs well, and even "backfires" less than it did with the original petcock. I like the change.
Back to top	IP Logged

Pages: 1

« Home