SuzukiSavage.com - Actual muffler inlet diameter

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Actual muffler inlet diameter

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Actual muffler inlet diameter (Read 47 times)

Greg Serious Thumper Offline Molon Labe Posts: 1251 Southeast PA, uSA Gender:	Actual muffler inlet diameter 08/16/14 at 14:38:35 I didn't see anything listed in the tech reference. I am wondering what the actual inlet diameter of our muffler is. Or the actual OD of the header. I don't have digital calipers or micrometers. I do know 1.75" is a little big. I am thinking somewhere around 42 or 43mm.
Back to top	2002 Savage. IP Logged

Srotag

Full Member

Offline

Have Thumper
Will Travel

Posts: 100
Wherever it is warm and sunny
Gender: male

Re: Actual muffler inlet diameter
Reply #1 - 08/16/14 at 15:39:04

Header pipe connection surface is 1-11/16 measured with old mic.

Stock muffler ID is a little hard to measure due to the way it is constructed, but it was tight on the header so I'm going to say 1-3/4

What HD calls 1.75 is a bit larger and takes the extra cuts and can piece as shown in mods to work well.

Happy with mine...

2005 S40 Ridin' on the back of our motorhome...Where we go, so goes Thumper

IP Logged

Greg Serious Thumper Offline Molon Labe Posts: 1251 Southeast PA, uSA Gender:	Re: Actual muffler inlet diameter Reply #2 - 08/16/14 at 18:19:06 Thanks. I suppose old school micrometers work too. I have a Dyna muffler on it now. I've had a lot of different ones on there. I am thinking of something different this time.
Back to top	2002 Savage. IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home