WD wrote on 05/10/14 at 08:53:33:Remove airbox door under right side cover. Unhook re/rec, place in airbox, drop wiring through airbox top intake and reconnect. Leave the door off...
The other wires you may need to stretch the harnesses. Run them under the fender rails if retaining them, otherwise, epoxy a conduit under the rear fender and run them through that. You will need to pull the rear wheel if you go the conduit route.
Note: The factory rear fender w/o a seat is uglier than a shaved down wormy dog's butt... You'll need to add a fender bib to hide all the lumps, bumps and holes.
Cool about the electrical stuff, but dang t
hat's a scary image...