SuzukiSavage.com - Front brake assembly

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Front brake assembly

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Front brake assembly (Read 61 times)

perajani

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 45
Finland

Front brake assembly
02/08/14 at 12:53:10

Just changed my pads. Clearance for the brake disk is ok, but as I assembly the pack it seems that whole brake package is a little too much outside. Disk is sort of taking contact to brake housing.

Did not remember to a photo when removing the bolts, but there seems to be a spacer. Should I but it whichside of Front fork?Outside on inside? I have the spare part pics, but in those front fork and brake housing are in different drawing, so cannot determine how to make assembly.

Would appreciate help.

IP Logged

anebv8 Senior Member Offline SuzukiSavage.com Rocks! Posts: 280 Rangiora,New Zealand Gender:	Re: Front brake assembly Reply #1 - 02/08/14 at 13:44:12 from a photo I seen,it bolts to the inside,dunno if it changes over the years
Back to top	Ago Solvo Intereo Puteus IP Logged

anebv8 Senior Member Offline SuzukiSavage.com Rocks! Posts: 280 Rangiora,New Zealand Gender:	Re: Front brake assembly Reply #2 - 02/08/14 at 13:45:50 http://suzukisavage.com/cgi-bin/YaBB.pl?num=1199986392 every photo you need...it's a bible to all savage owners
Back to top	Ago Solvo Intereo Puteus IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: Front brake assembly Reply #3 - 02/08/14 at 14:03:55 A photo would help... All the pictures I've seen show both washers to the outside. But if you need to fine tune the fit a bit, I've done one on the inside.
Back to top	Versey's Place Tech Section Index IP Logged

Oldfeller--FSO Serious Thumper ModSquad Offline Hobby is now "concentrated neuropany" Posts: 12673 Fayetteville, NC Gender:	Re: Front brake assembly Reply #4 - 02/09/14 at 01:39:18 Also, if you took the front wheel off you may have possibly put the wheel spacers on the wrong sides which will cause your rotor to drag because it is in the wrong place laterally.
Back to top	Former Savage Owner IP Logged

perajani YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 45 Finland	Re: Front brake assembly Reply #5 - 02/10/14 at 03:34:48 So I placed the washer n. 18 on other side and it seems to line up correctly. but while testing, I noticed that after pressing the lever, the brake gets stuck... So seems that I have to open it once more and also get bolts 7 and 9 out. I suppose bearing grease is suitable as a lube.
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home