I'm going to try to fix the rattle in my speedometer.  I got new springs, gasket/cushion, and some 2-sided self bonding tape.  I read a thread where someone used some rubber grommets so the springs wouldn't be up against the metal tabs on the bottom of the tank.  Does that sound sound like a good plan?  Again, any thoughts would be appreciated, thanks.

All I did was fashion a gasket from some of that gray, 1/8th inch thick, adhesive on one side foam rubber/tape. I had just bought a window unit air conditioner & that stuff was in the "Installation packet".. It goes between the speedo body & tank. Careful trimming & its not even visible.

Doing a tidy job of what I did was tedious but straight forward.

Old Rider, that's the tech section principle.

If simply replacing the springs with rubber tubing wins it, thats a LOT easier than what I did,,Thats a Minutes job,, mine was well over an hour of measuring, cutting, positioning,, PITA,, dude,, do the hose thing,,

Pain in the A**

.. or possibly an Arab bread.. ...

I got it fixed up, not to bad of a job.  I also put on a rapture pet as well.  Everyone, thanks for your input.