SuzukiSavage.com - Engine removal question

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Engine removal question

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Engine removal question (Read 74 times)

Henrik Junior Member Offline SuzukiSavage.com Rocks! Posts: 70 Sweden, Jönköping Gender:	Engine removal question 10/24/13 at 14:23:34 Iam going to remove the engine so i can do some fixes over the winter (suspect head plugg leak). However my question is do i have to remove the sidestand? (And then pull the engine out with with a lift from under) Or do you need a real bikestand? /Henrik
Back to top	IP Logged

justin_o_guy2

Serious Thumper

Offline

What happened?

Posts: 55279
East Texas, 1/2 dallas/la.

Re: Engine removal question
Reply #1 - 10/24/13 at 15:25:07

YOull be the first to pull the engine to fix that leak. You REALLY wanna do that?
YOull need to pull the pegs, because the bolts run thru them & clamp the case halves together,,
I cant remember how the sidestand mounts, if its part of the peg mount, then youll need to at least tie the bikes bars so it cant fall. Pulling the engine has been done by some who werent real stout by laying a bedspread/blanket. whatever is thick & soft on the ground & lay the bike down & pull the last bolts.

The people never give up their liberties but under some delusion.- Edmund Burke.

IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: Engine removal question Reply #2 - 10/24/13 at 15:37:22 You'll need to pull the side stand long enough to get the thru bolt out as it doesn't come straight out. Then you can either put it back on so the bike will stand or not.
Back to top	Versey's Place Tech Section Index IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Engine removal question Reply #3 - 10/24/13 at 18:24:54 Last time I was messin with mine I got some all thread & slid it in where the thru bolts went so I could ,, OHH yea! I was cleanin it up,, & wanted to be able to get to the peg mounts real good,, anyway, a piece of all thread a little smaller than the thru bolts, ground a bit roundish on the end,,
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

Henrik Junior Member Offline SuzukiSavage.com Rocks! Posts: 70 Sweden, Jönköping Gender:	Re: Engine removal question Reply #4 - 10/24/13 at 23:38:58 Thank you all for your answers!
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home