SuzukiSavage.com - Anyone successfully jetted a TM36 Mikuni?

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Anyone successfully jetted a TM36 Mikuni?

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Anyone successfully jetted a TM36 Mikuni? (Read 78 times)

smokin_blue

Serious Thumper

Offline

From Cafes to
Streetfighters! I
build them all!

Posts: 830
St. Paul, MN
Gender: male

Anyone successfully jetted a TM36 Mikuni?
07/21/13 at 15:15:23

After 4 years my project is finally rolling. (I will post project updates shortly) but now I am on to jetting the carb. I have searched the forum to see any info about TM36's might be out there. (Please note this is a different carb than the VM36 that has become a solid part of this forum)

What I am looking for is any knowledge base that might exist around the jetting that works for the TM36 on a Savage. Can anyone tell me what jets they used?

for reference I am running a stock piston with ported exhaust, high flow header and muffler, cone filter, and midrange cam.

Thanks!
Smokin_blue

My website http://street-unique.com

IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Anyone successfully jetted a TM36 Mikuni? Reply #1 - 07/22/13 at 03:39:33 What is ported exhaust?
Back to top	If you think there's good in everyone, you haven't met everyone. IP Logged

smokin_blue Serious Thumper Offline From Cafes to Streetfighters! I build them all! Posts: 830 St. Paul, MN Gender:	Re: Anyone successfully jetted a TM36 Mikuni? Reply #2 - 07/22/13 at 04:15:45 Sorry, just means that the exhaust track has been carved and finessed to flow better and open up some of the restriction that is naturally there in the stock head.
Back to top	My website http://street-unique.com IP Logged

Gyrobob Serious Thumper Offline Posers ain't motorcyclists Posts: 2571 Newnan, GA Gender:	Re: Anyone successfully jetted a TM36 Mikuni? Reply #3 - 07/22/13 at 18:08:01 smokin_blue wrote on 07/22/13 at 04:15:45: Sorry, just means that the exhaust track has been carved and finessed to flow better and open up some of the restriction that is naturally there in the stock head. Who did the porting?
Back to top	If you think there's good in everyone, you haven't met everyone. IP Logged

smokin_blue Serious Thumper Offline From Cafes to Streetfighters! I build them all! Posts: 830 St. Paul, MN Gender:	Re: Anyone successfully jetted a TM36 Mikuni? Reply #4 - 07/22/13 at 19:20:43 A buddy of mine is a drag racer and engine builder and he ports V8 heads as a side job. There is quite a bit on the forum of past porting work done by Lancer and others.
Back to top	My website http://street-unique.com IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home