Gyrobob
Serious Thumper
Offline
Posers ain't motorcyclists
Posts: 2571
Newnan, GA
Gender:
|
Digger said, "Also, I don't categorize torque wrenches according their to drive square sizes, I categorize them according to range. For instance, I've got two different 3/8" drive torque wrenches that have widely different ranges. One goes from 0-200 in-lb, the other goes from 0-600 in-lb.
IMO, you really can't get away with only one torque wrench if you want to use it in its most accurate range (usually the middle 60% of its total range, I believe).
I've got four beam-type torque wrenches. A 0-60 in-lb one, a 0-200 in-lb one, a 0-600 in-lb one, and a 0-150 ft-lb one. Each one gets called into service for work on the Savage.
Trying to save $$$ on tools is a false economy, penny wise and pound foolish, that will always come back to bite you in the ass......I'm just sayin'. "
Agree completely.
I use the tape trick, too. Occasionally, when another body is handy, I'll them read while I torque.
I have 1/4, 3/8, and 1/2. Like Digger said, though, the important part is to have the torque ranges covered,... low medium high.
I also concur with not getting cheapo tools. I try to get really good tools, but get them on sale. Often, for example, Sears will have some impressive sales on some pretty good stuff. Anyone who does any wrenching at all will eventually need a torque wrench. Keep your eyes peeled for when a good sale pops up, buy the wrench, and then it'll be there 6 months from now when you need it.
|