SuzukiSavage.com - Backfire.....COPS!!!!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Backfire.....COPS!!!!

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

Backfire.....COPS!!!! (Read 374 times)

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: Backfire.....COPS!!!! Reply #15 - 09/12/12 at 14:16:46 Don't hit the impact driver w/o the screw being supported from below or you'll break the tab off. And I preferr to grab the heads with a vice grip. They usually break loose easy that way. Harbor Fright has a small impact driver with a long tip that's good with the slide screws. Don't F those up, no way to get at them otherwise.
Back to top	Versey's Place Tech Section Index IP Logged

LANCER Serious Thumper Alliance Member Offline Savage Beast Performance Parts Posts: 10663 Oklahoma Gender:	Re: Backfire.....COPS!!!! Reply #16 - 09/12/12 at 17:20:02 Dude, it's all about making sure there are no air leaks in the exhaust system and adjusting the pilot screw ( CCW ) to richen the low throttle range ( idle - 1/4 throttle ). That WILL stop the backfiring.
Back to top	IP Logged

LouSiana

Junior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 73
Hannover, Germany
Gender: male

Re: Backfire.....COPS!!!!
Reply #17 - 09/13/12 at 13:55:21

LANCER wrote on 09/12/12 at 17:20:02:

Dude, it's all about making sure there are no air leaks in the exhaust system and adjusting the pilot screw ( CCW ) to richen the low throttle range ( idle - 1/4 throttle ).

That WILL stop the backfiring.

I do subscribe to these points of view, and would add the advice to first weld the holes around the stock exhaust.

IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: Backfire.....COPS!!!! Reply #18 - 09/13/12 at 14:40:07 LouSiana wrote on 09/13/12 at 13:55:21: I do subscribe to these points of view, and would add the advice to first weld the holes around the stock exhaust. This mod has been done many times before w/out adverse effect. Unless it's too loud, I would leave it be. Quick and easy fix is to put a screws in the holes.
Back to top	Versey's Place Tech Section Index IP Logged

223fan YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 45 Crawley WV Gender:	Re: Backfire.....COPS!!!! Reply #19 - 09/16/12 at 07:07:32 Not to hi-jack this thread but... I have the same problem with my 2012,going to check for leaks today can anyone point me to some instructions on the pilot screw[ccw].
Back to top	IP Logged

justin_o_guy2

Serious Thumper

Offline

What happened?

Posts: 55279
East Texas, 1/2 dallas/la.

Re: Backfire.....COPS!!!!
Reply #20 - 09/16/12 at 07:15:04

Tape around 1/8th drill bit so bit wont go flying thru. Dont bash into the adjuster,,

First step, Gently, very gently, brass pointed tip,, close it off, count the turns, Write it down, Now, you can always get back to square one.,
Open it again, to stock location, & open another 1/2 turn. Go for a ride, adjust a litle, ride some more.

Others will be along to warn about Too Far.

The people never give up their liberties but under some delusion.- Edmund Burke.

IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home