verslagen1
YaBB Moderator ModSquad
Offline
Where there's a will, I want to be in it.
Posts: 28886
L.A. California
Gender:
|
Here's an idea for you...
You can get set screws in several types of points. Common is a cup point. What you what is cone point, at least initially.
Second, drill and tap the bar clamp, but do so off to the side, not centered.
This will allow you to flip the cap, readjust the bar and lock it in to new clean position.
I'd also go high on one side and low on the other so that you can also switch caps from one side to the other and bite into new territory.
When you're happy, there's another type called dog point, pull the cone points and replace the cone points and drill the bars at that setting.
|