justin_o_guy2
Serious Thumper
Offline
What happened?
Posts: 55279
East Texas, 1/2 dallas/la.
|
I would get my little soldering torch ( $10.00 at Lowes), fill it with butane & remove the soldering tip & heat that thing up good, then, Id take my squirt bottle ( set to pump a stream) & squirt Ice Water in the hole youve drilled, then Id put a penetrating oil on it & let it sit. I wouldnt stick an eze out in it yet,.They have to spread the dutchman to bite it,,YOuve got stuff sticking up I think.. Id work at it with alternating heat & cold water & oil, then Id take a pin punch & stick down to the bottom & give it a few quick smacks with a lite hammer. Ill bet you can cut a groove across it ( IF ya do it so you make square shoulders) & back it out with vise grips on a screwdriver,,
Or maybe grind a bolt down to go in the hole & JB weld it,,If it goes deep enough & you get enough surface area covered, it otta bring it out,
Antisieze is your friend, use it going back together,
& FWIW, you could spend hours messin with it doin it my way,, or just a minute or so with an eze out, OR, the eze out could cause you great pain,, I have some, I even have some tungsten carbide ones, I guess theyre about the best Ive seen, & when they work out,, theyre the greatest! Ohhh, but when they dont,,
|