Here's the link top the chain "COVERSION" thread...
http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1174239333

I haven't seen anyone else using this pulley cover with the chain conversion, but that's my plan; it's gonna be a while though; rest of the bike is still in pieces two states away. Hoping to get it back up here next weekend...

Mmmm.... Countersunk goodness! That looks awesome.

For bars check lowbrow customs or dime city cycles to start, are you wanting taller risers than stock?

I use the stock risers, my bars are flat with 5 degrees of backsweep and are 28 inches wide. If your risers are lower than stock your controls wont work unless the bars are wide and that's not a LaneSplitter now is it........all you need is basic 1 inch flat bars with a backsweep around 5 degrees any width that you like with the controls where you like them. Once you get there I can show you how to measure for a stop and I'll bend ya one up.

skeebo, I sent you a PM regarding a pulley/belt guard.

hey man just wondering should i take off the exhaust to tape it? and do i have to get another exhaust gasket or is it possible to re-use it?   chances are new one right. haha

If the gasket is a copper ring you can anneal it and re-use it. Simply heat with a blow torch until it is cherry red and then toss it in a bucket of water. That should soften the gasket enough to re-use it.