SuzukiSavage.com - First Post!! Electrical ?(control unit relay solen

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › First Post!! Electrical ?(control unit relay solen

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

First Post!! Electrical ?(control unit relay solen (Read 57 times)

hawaiibobber

YaBB Newbies

Offline

SuzukiSavage.com
Rocks!

Posts: 4

First Post!! Electrical ?(control unit relay solen
03/17/12 at 12:45:27

I just replaced this part because one of the fuses had blown/broke off completely from the unit (part 32910-24B10) out of the 6 male ends only 5 were running a connection. Because the blown female end looked pretty bad I just switched the wire over to the open connection and connected it that way.

My question is if that is OK or does it have to go to that particular spot on the control unit and the unused tab was unused for a reason? Should I leave it as I rewired it or should I clean it out and put it back the way it was?

Thanks for any help!!

IP Logged

verslagen1 YaBB Moderator ModSquad Online Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: First Post!! Electrical ?(control unit relay s Reply #1 - 03/17/12 at 13:14:17 Can't say why the decomp controller has an open connection. Most likely cause it's not used and swapping a wire over to it might be harmful, might not. Depending on what wire you swapped over... might not do anything. I would think the wire would have to go to the original spot to work.
Back to top	Versey's Place Tech Section Index IP Logged

hawaiibobber YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 4	Re: First Post!! Electrical ?(control unit relay s Reply #2 - 03/17/12 at 19:06:34 Thanks for the insight...I might just switch it over to be safe. Do you know if the unit is designed for specific wires to run to a specific male end or is it just all the same? Furthermore I know nothing about electronics LOL...let alone much else
Back to top	IP Logged

justin_o_guy2

Serious Thumper

Offline

What happened?

Posts: 55279
East Texas, 1/2 dallas/la.

Re: First Post!! Electrical ?(control unit relay s
Reply #3 - 03/17/12 at 22:18:37

If it was all the same, wouldnt they just run one wire? Generally, a wire leaves somewhere & is supposed to go to somewhere else,, & no other place other than the designed destination, SO,, If there was a blank spot on a connector & you moved the wire that feeds in & the wire that feeds out to the blank spot, you did okay,,if ya just moved one of them,,, ehhh not so great,,

The people never give up their liberties but under some delusion.- Edmund Burke.

IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home