SuzukiSavage.com - Removing the spacer

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Removing the spacer

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Removing the spacer (Read 121 times)

drd1135

YaBB Newbies
2004 No Login

Offline

I love YaBB 1G -
SP1!

Posts: 14
Southwest Virginia
Gender: male

Removing the spacer
02/10/12 at 10:52:04

Hey folks,

Almost through with disassembling the carb. Every screw has been solvent and impact driver. Unfortunately, this is also true of the the two little screws that how the infamous white spacer in place. I've tried lots of liquid wrench, but no luck. I also can fit the impact driver in there. Any suggestions on getting those two little crews out? Thanks.

IP Logged

Tom Dooley YaBB Newbies Offline SuzukiSavage.com Rocks! Posts: 25 South Louisiana Gender:	Re: Removing the spacer Reply #1 - 02/10/12 at 11:53:19 For years all I have was the 3/8" drive impact driver. Then someone posted on this forum that Harbor Freight has the small 1/4" drive impact driver available. I bought one from Harbor Freight for $4.95 and it worked great for these small phillips heads screws. Make sure you use the correct size phillips head. Good luck.
Back to top	IP Logged

Serowbot YaBB Moderator ModSquad Offline OK.... so what's the speed of dark? Posts: 28651 Tucson Az Gender:	Re: Removing the spacer Reply #2 - 02/10/12 at 15:23:48 If those two screws are stuck... it's a booger... Even a 1/4" impact won't fit down that tube... Have to use super zen mojo.... and your best tiny tip screwdriver...
Back to top	Ludicrous Speed !... ... ... IP Logged

drd1135 YaBB Newbies 2004 No Login Offline I love YaBB 1G - SP1! Posts: 14 Southwest Virginia Gender:	Re: Removing the spacer Reply #3 - 02/12/12 at 18:16:31 I got 'em. I have a 3/8 inch impact driver from Lisle and i managed to get it in there. I couldn't see, of course, so I had to fiddle around quite a bit.
Back to top	IP Logged

LANCER

Serious Thumper
Alliance Member

Offline

Savage Beast
Performance Parts

Posts: 10661
Oklahoma
Gender: male

Re: Removing the spacer
Reply #4 - 02/13/12 at 02:32:22

This is the 1/4" impact driver from Harbor Freight and it easily fits down inside the carb slide with room to see what you are doing. I've been using one for years for the specific purpose to getting to those 2 tiny screws that hold the plate over the jet needle
Only $4.99 on their website right now.

http://www.harborfreight.com/media/catalog/product/cache/1/image/9df78eab3352...

IP Logged

Doug Junior Member Offline SuzukiSavage.com Rocks! Posts: 95 Texarkana, AR Gender:	Re: Removing the spacer Reply #5 - 02/13/12 at 02:34:57 @Lancer Nice.
Back to top	"Can't do + won't do = don't do. Can do + will do = do do." xD IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home