liltimmy wrote on 02/01/12 at 08:38:30:I like the ones you are using but I would like the heavy duty ring like the one on the left. Also, I was wondering if you might have the one on the left that will fit through the whole without drilling for the rear bolt test we talked about.
Thought about this for a minute...
easy way to determine the clearance.
1. remove shocks and let the tire ride on the fender.
2. remove the rear bolt and stick a pin thru the threaded hole.
3. measure the length that can protrude thru to stike the tire.
If it's over half an inch no worries at all.
Then I would just need to know how much grip you'd need.
block the back side of the mounting location.
stick the pin in and measure the length that sticks in from the top of the bracket to the backside.
The button head would look good there.