Donate!
Welcome, Guest. Please Login or Register :: View Members
Pages: 1
Send Topic Print
Ryca threaded rod problems (Read 60 times)
wombat
Full Member
***
Offline

SuzukiSavage.com
Rocks!

Posts: 109

Ryca threaded rod problems
08/22/11 at 18:10:01
 
Usually connecting rods on rear sets are threaded in opposite directions at each end so their length can be adjusted. However, in my kit from Ryca the ends of the shift connector, rear brake, and decompression rods all thread the same way (righty tighty). Plus, the threads are a little off and won’t accept the specified 6 mm nuts and end fittings.
Has anyone else encountered this? Am I doing something wrong? Or has Ryca screwed up?
Dave
Back to top
 
 
  IP Logged
Gyrobob
Serious Thumper
*****
Offline

Posers ain't
motorcyclists

Posts: 2571
Newnan, GA
Gender: male
Re: Ryca threaded rod problems
Reply #1 - 08/22/11 at 19:41:44
 
wombat wrote on 08/22/11 at 18:10:01:
Usually connecting rods on rear sets are threaded in opposite directions at each end so their length can be adjusted. However, in my kit from Ryca the ends of the shift connector, rear brake, and decompression rods all thread the same way (righty tighty). Plus, the threads are a little off and won’t accept the specified 6 mm nuts and end fittings.
Has anyone else encountered this? Am I doing something wrong? Or has Ryca screwed up?
Dave



I had some trouble with the threads too.  I had to clean them up with taps and dies.   It felt like they were being crossthreaded or something.

The worst situation was the ignition switch panel.  The powder coating munged up the threads something awful.  That stuff is tough.  I spent one whole evening getting those panels ready to install.

Back to top
 
 

If you think there's good in everyone, you haven't met everyone.
  IP Logged
sbaugz
Ex Member




Re: Ryca threaded rod problems
Reply #2 - 08/23/11 at 18:37:09
 
hmm, did not have any problems like that with mine.
Back to top
 
 
  IP Logged
Gyrobob
Serious Thumper
*****
Offline

Posers ain't
motorcyclists

Posts: 2571
Newnan, GA
Gender: male
Re: Ryca threaded rod problems
Reply #3 - 08/23/11 at 20:42:46
 
sbaugz wrote on 08/23/11 at 18:37:09:
hmm, did not have any problems like that with mine.


Lucky you.
Back to top
 
 

If you think there's good in everyone, you haven't met everyone.
  IP Logged
Pages: 1
Send Topic Print


« Home

 
« Home
SuzukiSavage.com
09/25/24 at 14:24:33



General CategoryRubber Side Down! › Ryca threaded rod problems


SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.