Mattdw
Full Member
Offline
Posts: 193
Frisco, TX
Gender:
|
Just picked up an '07 with 980 miles on it for a steal of only $2000 (IMO). Garage kept, original owner. Here's the kicker...had been sitting since August of last year so the battery was dead. Took a long time, but I was able to jump start the bike. It was already almost out of gas, so I didn't drain it, but I added about 1/4 of a can of Seafoam and filled it up fresh. I was able to ride it home the 20 or so miles. At idle, it will only stay running with the choke pulled fully out. Push in the choke, bike dies. Once you get past 35 mph or so it runs better when I push the choke in. So, it was kind of an interesting ride home with a lot of stop lights, but, I made it. Anyway, I'm a little bit stumped and not sure where to start other than probably to pull the carb and just clean it all out.
One thing to note...while I was jump starting it, gas started pouring out of the carb vent tubes. To finally get it started, I disconnected the vacuum line, left the carb in the ON position and cranked it for a long time until finally it wasn't flooding any more. I replaced the vacuum line and now it idles, but only with the choke out, as I stated before.
I'm thinking maybe the carb float is sticking, but I didn't think that would have any effect on the choke position.
I'm sure many of you have run into this issue before...
Many Thanks!
Matt
|