SuzukiSavage.com - Question about cam timing

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Question about cam timing

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1 2

Question about cam timing (Read 205 times)

Bubba Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 956 Denver, CO Gender:	Re: Question about cam timing Reply #15 - 01/13/11 at 10:30:25 Thanks, I wasn't gonna actaully run it, just check to make sure things are spinning freely. I was planning to just run a jumper from the battery - to the starter motor housing and then just touch the + to the starter pole VERY briefly!!!!
Back to top	'06 lt Blue, Dyna Power pipe, air screw 2 1/4 turns, 52.5 pilot w/ bleed holes, 150 Main, 2/3 spacer, Pirelli MT66 tires, Raptor petcock, 412-4006 Progressive shocks IP Logged

RidgeRunner13

Serious Thumper

Offline

haulin' the
groceries!

Posts: 649
Mustang Island, Texas
Gender: male

Re: Question about cam timing
Reply #16 - 01/13/11 at 10:52:10

Bubba wrote on 01/13/11 at 10:30:25:

Thanks, I wasn't gonna actaully run it, just check to make sure things are spinning freely.
I was planning to just run a jumper from the battery - to the starter motor housing and then just touch the + to the starter pole VERY briefly!!!!

First turn it over by hand slowly several revolutions to be sure nothing hits or binds.Then try the starter. Cool

Wind me up & watch me run, I ain't never had too much fun!

IP Logged

Pages: 1 2

‹ Previous topic | Next topic ›

« Home