I think option 1 is to make sure it's clean and not clogged.
Option 2, since you're bound to replace it and throw it over your shoulder anyway, use Lancer's trick and open it up slightly.
Option 3, R&R with a bigger size (get same size just in case).
Now to do this I'd get the small impact driver from harbor freight. And modify the tip to fit the jet and cut the end so it's chisel like and will dig into the jet as you wack it with a hammer. Cut it half and half so that the flat is on the driving side kinda like a drill.
Yes for all 3 options you need to take the carb out. oh the horror.