Hello all,

I am almost done with the bike. It is a 2000 and it came with no right hand controls. I obtained one locally for a 2006 and I need some help. I have a Clymers manual but it only goes up to 2004. I have figured out most of the wiring but am stuck with a couple of wire connections. I was wondering if anyone has the answers to the following wires. I want to get this going but don't want to cross wires. I would appreciate the help.

Thanks,

Starter Switch
White                        Orange/White of kill switch
Yellow/white              ????
Yellow/Green             (eventually) to starter relay
Orange/Red               ????

Engine Stop      
Orange/White            White to Starter Switch and ????
Orange/Black            Sidestand relay

Front Brake      
Black/Blue                      Rear Brake Light
Black/Red                      Power

Hazard Switch
Light Blue                      Don’t Care            
Light Green               Don’t Care
Black                        Don’t Care

thumperclone wrote on 10/04/10 at 17:47:16:


I have a new (2006) RH control switch with 4 wire starter switch trying to connect to the original (2000) wire harness. The hazard wiring is of no concern currently, just wanting to get the starter switch and kill hooked up. I have the front brake light switch working. Just not sure about the wires stated.

Thanks,
DV

engine stop sw           O/B(from ss relay) &  
O/W (to ignitor)  which also connects to starter sw  along with Y/G(back thru safety ckt @ clutch lever sw)
now you have two wires left over from start sw think those kill the head lamp in 05 for  more starting current
cap them off