After checking the valves today I decided to go through and check lots of other stuff just to make sure they were all good.
Used a candle to find that I did have a small exhaust leak, but exhaust was a little warm to try and fix that right now.
I dug through the box of extra parts that the PO had taken off when he bobberized the bike before I had it and found the lower belt guard and matching bolts to put it on. Took off the front pulley cover and attached the lower belt cover. Things are looking good
Put on the pulley cover and cinche down the first two screws, but when I went to get the third one towards the rear I heard a POP
sure enough the bolt snapped. Pull the other two out to see how bad it is, and it's snapped almost flush, only showing one thread or so.
This all happened when I was just putting things back together at 11:30 so I think I will look at it in the morning and see how good I am with an extractor set
If that doesn't work I guess I will have to try and go get a set of reverse drill bits and try that too.
First one of these soft bolts that I've snapped so far (boogered up the head on a few, but never snapped one)