i have noticed receantly that at any high rev in gear or high speed aswell will cause my blinker to blinkk fast, my 4 ways work fine and only if i am in nuetral or stopped at light high revs don't do it.and no w today my light wouldn't turn on unless i flashed my brites on and off now thelight works good any insight would be appreciated

is that probaly what is
even though 4 ways work ???? what about a relay

well i checked everything but the regulator with voltometer and checked all connections cleaned them and i checked the rela it was pulling bout 4 ohm does anyone know what it is supposed to be at. my switch is fine but my darn manual just doesnt tell how to check the relay

texsam wrote on 07/26/10 at 19:31:05:


ssm page 6-4 table
there are 6 wires on the reg/rectifier to check with your ohm meter set at 1k ohms
POS + probe                NEG - probe                  k ohms
R                                  y1,y2,y3                                3
                                   b/w                                      7.5
                                   o/b                                       60

Y1,Y2,Y3                       b/w                                        3
                                   o/b                                       40

B/W                              o/b                                      28

O/B                               b/w                                     4.5


hope this helps