SuzukiSavage.com - 19mm sockets as risers

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › 19mm sockets as risers

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

19mm sockets as risers (Read 139 times)

RTC Senior Member Offline SuzukiSavage.com Rocks! Posts: 260 El Paso, TX (Ft. Bliss) Gender:	19mm sockets as risers 07/18/10 at 22:59:11 someone one here mentioned one time that they used 19mm sockets as risers. i would like to know how to do this mod so i can go the drag bar route for under $100. thanks
Back to top	IP Logged

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28905
L.A. California
Gender: male

Re: 19mm sockets as risers
Reply #1 - 07/18/10 at 23:25:20

You can use 11/16 or bigger. Just get 2 matching sockets with 3/8" drive.
The bolt retaining the stock handlebar clamps is slightly larger than 3/8".
I replaced those with 3/8 bolts as they fit inside the sockets w/o mod.
to figure out the new length, take the socket and one bolt lay them end to end and that is how long to get the new bolt. I'd get new self locking nuts and or jam nuts.

Versey's Place
Tech Section Index

IP Logged

james may

Senior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 252
holyoke, ma
Gender: male

Re: 19mm sockets as risers
Reply #2 - 07/19/10 at 05:28:47

Should be able to do a set of drag bars for under 100 anyways. 30 for the bars and 30 for the risers. Check around and go to Harley accessorie stores.(Harley bars are 1" just get the ones without dimples). The socket risers could look cool to. Standard socket(1"). Probly end up costing 10-15$. Deep well(2.5") probly bit more 25-30$.

Weightloss Blog
http://atomsweightlosschronicles.blogspot.com

IP Logged

Phelonius Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1897	Re: 19mm sockets as risers Reply #3 - 07/19/10 at 10:20:25 Make risers to what ever length you want out of aluminum round or square stock by drilling the length and using a long bolt. http://p1.bikepics.com/pics/2008/07/02/bikepics-1340295-full.jpg Enlarge the image for a good look at the risers. Phelonius
Back to top	Phelonius IP Logged

ralfyguy Serious Thumper Offline Posts: 932	Re: 19mm sockets as risers Reply #4 - 07/19/10 at 10:41:05 Phelonius is that a chain oiler on the left?
Back to top	IP Logged

Serowbot YaBB Moderator ModSquad Offline OK.... so what's the speed of dark? Posts: 28850 Tucson Az Gender:	Re: 19mm sockets as risers Reply #5 - 07/19/10 at 11:11:16 I made mine out of BMX bicycle footpegs...
Back to top	Ludicrous Speed !... ... ... IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home