SuzukiSavage.com - Clutch question

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Clutch question - wave washer

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Clutch question - wave washer (Read 68 times)

BurnPgh Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1732	Clutch question - wave washer 06/24/10 at 14:26:33 Clymers says to install it with the concave side facing outward but in Chapter 5 Fig. 43 It shows that the "proper" way to install it is with the concave side facing inward. Which is it?
Back to top	IP Logged

verslagen1

YaBB Moderator
ModSquad

Offline

Where there's a
will, I want to be
in it.

Posts: 28884
L.A. California
Gender: male

Re: Clutch question - wave washer
Reply #1 - 06/25/10 at 12:01:32

Is it 2may-to or 2mat-to?

If I recall correctly... and I wish I could give you a picture...

There's a machined inside diameter and a machined outside diameter with a ledge immediately adjacent. The corner of the wave washer should nest in each one. Otherwise the corner would be locking the movable ledge against the fixed diameter.

Versey's Place
Tech Section Index

IP Logged

BurnPgh Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1732	Re: Clutch question - wave washer Reply #2 - 06/25/10 at 12:36:19 I took a chance and went by the picture in fig 43 and it worked beautifully.
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home