SuzukiSavage.com - Electrical connector

Donate!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Electrical connector

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

Electrical connector (Read 47 times)

LANCER Serious Thumper Alliance Member Offline Savage Beast Performance Parts Posts: 10661 Oklahoma Gender:	Electrical connector 01/15/10 at 15:34:10 Quick question about connectors. I picked up a throttle assembly from an '05-later model bike and the connector has more pins than my '96; I am assuming that it is for the added feature of the emergency blinkers. Question is, is this just a matter of removing a pin or are there other wiring changes that would be needed ?
Back to top	IP Logged

justin_o_guy2 Serious Thumper Offline What happened? Posts: 55279 East Texas, 1/2 dallas/la.	Re: Electrical connector Reply #1 - 01/15/10 at 16:46:10 Can you look at the bike end of the connector & compare to the throttle end & see if a couple of pins go to blank spots on the bike end? If so, maybe you can just plug it in & not worry about it? Orr,, use an Ohm meter & see where the connector wires run now?
Back to top	The people never give up their liberties but under some delusion.- Edmund Burke. IP Logged

Yonuh Adisi FSO Serious Thumper Offline Savage Jedi (Knight) Posts: 3622 Pilot Valley NV, aka Tatooine Gender:	Re: Electrical connector Reply #2 - 01/15/10 at 17:35:21 Does the connector you are referring too, look like this? This is on my 2000 wiring harness. I traced this connector to the harness that goes to the turn sigs and high beam switches. Bobbert and I just went through this comparing my 2000 harness to his '96. His does not have this plug while mine does.
Back to top	Check out Flight of Destiny http://www.amazon.com/dp/B00H9130XC IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

« Home