Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
Rubber Side Down!
› steering stem bearing removal
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages:
1
2
steering stem bearing removal (Read 279 times)
Dave
YaBB Moderator
ModSquad
Offline
SuzukiSavage.com
Rocks!
Posts: 18099
Camp Springs, Kentucky
Gender:
Re: steering stem bearing removal
Reply #15 -
08/20/14 at 03:44:46
Jsud04 wrote
on 08/20/14 at 03:13:11:
Yea....face palm...but how about an improvised tool for this torquing?
If you have not taken the races out, and only had the forks off....this initial torquing is not really necessary. I believe the purpose is to make sure the races are pulled into place squarely with the bearings.
Don't worry about this issue too much. Just tighten the nut really snug, wiggle the forks a bit, then back the nut off until you get a nice smooth action of the forks. Don't make it so loose that you get any movement front/back if you grab the bottom of the forks and pull/push on them.
Dave
Back to top
Someday I will be old......But not today!
IP Logged
Pages:
1
2
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
»» Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
- The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
09/28/24 at 02:29:40
›
General Category
›
Rubber Side Down!
› steering stem bearing removal
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.