Donate!
Welcome, Guest. Please Login or Register :: View Members
Pages: 1
Send Topic Print
Drive Belt Tension (Read 77 times)
91 UK SAVAGE
YaBB Newbies
*
Offline

SuzukiSavage.com
Rocks!

Posts: 48
weston super mare,england
Gender: male
Drive Belt Tension
06/30/09 at 09:16:48
 
Hi. could anyone please help? do you know the correct drive belt tension as i do not have a belt tensioner tool. i have changed the belt and need to know a point to point tension in mm
Back to top
 
 
  IP Logged
Yonuh Adisi FSO
Serious Thumper
*****
Offline

Savage Jedi (Knight)

Posts: 3622
Pilot Valley NV, aka Tatooine
Gender: male
Re: Drive Belt Tension
Reply #1 - 06/30/09 at 11:42:05
 
The recommended method here is grab the lower part of the belt midway between the the sprockets, if you can turn it 90 degrees it is fine, if you can turn it more, you need to tighten, less you need to loosen. No one here bothers with the gauge and most of us just throw the thing out.

For future reference, all questions should be posted in the "Rubber Side Down" section, this section is for how-to not how do I
Back to top
 
 

Check out Flight of Destiny http://www.amazon.com/dp/B00H9130XC
  IP Logged
91 UK SAVAGE
YaBB Newbies
*
Offline

SuzukiSavage.com
Rocks!

Posts: 48
weston super mare,england
Gender: male
Re: Drive Belt Tension
Reply #2 - 06/30/09 at 13:06:14
 
Hi, cheers, thanks a lot, i will try this, sorry i put message in the wrong section, will keep this in mine,by the way it is a new one thanks again, regards

sorry does the wheel have to be off the ground?
Back to top
 
 
  IP Logged
Yonuh Adisi FSO
Serious Thumper
*****
Offline

Savage Jedi (Knight)

Posts: 3622
Pilot Valley NV, aka Tatooine
Gender: male
Re: Drive Belt Tension
Reply #3 - 06/30/09 at 13:16:02
 
It would be best, that way if you have to tighten you can spin the wheel to be sure the belt is running in the center of the sprocket.

Don't worry too much about posting in wrong area, I did the same thing my first post.
Back to top
 
 

Check out Flight of Destiny http://www.amazon.com/dp/B00H9130XC
  IP Logged
AngloSaxon
Full Member
***
Offline

I'd rather have one
big one than four
small ones.

Posts: 141
Framingham MA
Gender: male
Re: Drive Belt Tension
Reply #4 - 06/30/09 at 15:01:48
 
You're being way too nice Running Bear! You should have told him to go down the pub and eat ten pickled eggs followed by a pint of worst bitter they have on tap.........that should cover his sins...lol

BTW - How is beautiful down town Weston Super Mare? It's been a long time since I was there, about thirty years ago.
Back to top
 
 

As yet, a Bog Standard '87 with a big arse Harley muffler.
  IP Logged
Pages: 1
Send Topic Print


« Home

 
« Home
SuzukiSavage.com
09/24/24 at 10:24:06



General CategoryRubber Side Down! › Drive Belt Tension


SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.