Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
Rubber Side Down!
› can change pilot and main jet without moving carb?
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages: 1
can change pilot and main jet without moving carb? (Read 112 times)
tomtaz1975
YaBB Newbies
Offline
Let's Ride!
Posts: 34
Milwaukee, WI
Gender:
can change pilot and main jet without moving carb?
06/04/09 at 16:41:13
Do you have to remove the assembly, or can you change these from underneath just by removing the bowl?
It looks like there is enough room...but I don't know if you'll be able to see what you are doing or not. Waiting to get my main jet tool and so I'm just curious.
Back to top
2001, Yellow, Dunstall Megaphone Long, 155 Main, 55 Pilot, no spacer, K&N Filter.
IP Logged
srinath
Serious Thumper
Offline
I love YaBB 1G -
SP1!
Posts: 5349
Re: can change pilot and main jet without moving c
Reply #1 -
06/04/09 at 17:30:42
Yes you can ... but not if the phippips screws are stuck ...
I usually replace the phillips screws on the bowl with stainless allen head bolts, and you can yank em anytime and clean and swap jets ... unless the jets are stuck in there ...
Cool.
Srinath.
Back to top
IP Logged
seviersavage
Senior Member
Offline
SuzukiSavage.com
Rocks!
Posts: 364
Smoky Mountains Tennessee
Gender:
Re: can change pilot and main jet without moving c
Reply #2 -
06/04/09 at 18:11:31
With my vm carb I can loosen the clamps that hold carb in boots and spin it around to gain access to the jets easy. If you disconect the throttle cable maybe you can spin it in place, make it easier if you can.
Seviersavage
Back to top
IP Logged
bill67
Serious Thumper
Offline
old tired
Posts: 8517
genoa city wisconsin
Gender:
Re: can change pilot and main jet without moving c
Reply #3 -
06/04/09 at 19:19:50
I replaced the fuel bowl with allen bolts,I f I take the bowl off again I will replace with phillip screws their a lot quicker to take off you can spin the screwdriver.
Back to top
william h krumpen
IP Logged
dasch
Serious Thumper
Offline
SuzukiSavage.com
Rocks!
Posts: 1137
Re: can change pilot and main jet without moving c
Reply #4 -
06/05/09 at 00:36:59
I got allens, and a cheap set of L-shaped allen wrenches with the ball-shaped end on the long strech of the "L". Those do the job even under slight angle and you can spin them easy. Got them in a chinese shop, like Dollar-tree in US.
Back to top
IP Logged
Boule’tard
Serious Thumper
ModSquad
Offline
Master of the
Obvious
Posts: 1620
Austin TX
Gender:
Re: can change pilot and main jet without moving c
Reply #5 -
06/05/09 at 08:23:29
seviersavage wrote
on 06/04/09 at 18:11:31:
With my vm carb I can loosen the clamps that hold carb in boots and spin it around to gain access to the jets easy. If you disconect the throttle cable maybe you can spin it in place, make it easier if you can.
Seviersavage
DOH! Why didn't I think of that. Spent several hours yesterday trying to get the screws out, loosening the top of the battery box, trying to finagle the bowl past the battery box, etc.. but it can be done.
Back to top
That which can be destroyed by the truth should be. - P.C. Hodgell
IP Logged
matt
Full Member
Offline
da na na na na
mattman
Posts: 228
Winter Springs, FL
Gender:
Re: can change pilot and main jet without moving c
Reply #6 -
06/05/09 at 09:25:40
I have managed to get the entire carb out only removing the gas tank
I dont know if its good practise but i remove the clamps on each end of carb, then i bend the rubber on the backside of the carb back so it gives a few inches to wiggle the carb off the engine.
Eventually im sure the rubber will crack or something but quick carb removal.
Back to top
IP Logged
srinath
Serious Thumper
Offline
I love YaBB 1G -
SP1!
Posts: 5349
Re: can change pilot and main jet without moving c
Reply #7 -
06/05/09 at 11:41:07
I wont tip the carb if I were doing it, all the crap in the bottom will get into the jets ... OK fine you're replacing the jets ... OK bad example.
Also wiggling the airbox boot is OK it should take a little bit of that just fine.
Also you can replace the manifold to engine bolts with hex head and simply unscrew those and remove the carb with the manifold if you're removing the whole thing.
In fact a virago 1100 has to be removed with 1 manifold still attached ... once again who thought a V twin was the logical way to add displacement. Probably the worst way to add displacement.
Cool.
Srinath.
Back to top
IP Logged
Serowbot
YaBB Moderator
ModSquad
Offline
OK.... so what's the
speed of dark?
Posts: 28657
Tucson Az
Gender:
Re: can change pilot and main jet without moving c
Reply #8 -
06/05/09 at 12:09:05
Arms like a monkey you need......
Back to top
Ludicrous Speed !... ...
...
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
»» Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
- The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
09/26/24 at 18:20:27
›
General Category
›
Rubber Side Down!
› can change pilot and main jet without moving carb?
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.