SuzukiSavage.com - Riser size

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Riser size

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Riser size (Read 65 times)

littlefights

Junior Member

Offline

SuzukiSavage.com
Rocks!

Posts: 54

Gender: male

Riser size
05/12/09 at 20:07:02

I did a search and looked through my Clymer manual, but couldn't find any specific size for the riser bolts. I've got an '86 with the buckhorns and I'm wanting to switch them out to a dragbar with 4 inch risers. There are a ton of "Harley" risers on ebay - will those work as is? Or will they require some fooling around with? Is there a specific bolt size to look for that will work out of the box?

Thanks.

IP Logged

verslagen1 YaBB Moderator ModSquad Offline Where there's a will, I want to be in it. Posts: 28886 L.A. California Gender:	Re: Riser size Reply #1 - 05/12/09 at 20:46:44 Harleys are 1/2" ours are close to 3/8". Harleys will fit if you leave out the spacer and drill out the washers. Don't get the ones with a bridge between the 2 risers.
Back to top	Versey's Place Tech Section Index IP Logged

diamond jim Serious Thumper Offline Posts: 1425 North Alabama Gender:	Re: Riser size Reply #2 - 05/12/09 at 23:05:57 Most use a 1/2 x 13 thread bolt. Some use 1/2 x 20 thread bolt. Read this thread: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1233443946/10#10
Back to top	IP Logged

Phelonius Serious Thumper Offline SuzukiSavage.com Rocks! Posts: 1897	Re: Riser size Reply #3 - 05/13/09 at 09:38:01 I made my own from aluminum scrap. One inch square stock cut to length, then one end was tapered in a lathe and cut to fit the part that grips the bar. Drilled full length and a through bolt fitted down the whole thing. They have served me well for more than 30,000 miles now. Phelonius
Back to top	Phelonius IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home