PTRider
|
I think-- Spauling means Spalling, "Spall are flakes of a material that are broken off a larger solid body and can be produced by a variety of mechanisms, including as a result of projectile impact, corrosion, weathering, cavitation, or excessive rolling pressure (as in a ball bearing). Spalling and spallation both describe the process of surface failure in which spall is shed."
Gauling means Galling, "Galling, according to ASTM standard G40 (2006), is: “a form of surface damage arising between sliding solids, distinguished by microscopic, usually localized, roughening and creation of protrusions (i.e., lumps) above the original surface”. In other words galling is material transfer from one metallic surface to another caused by movement and plastic deformation. Galling usually refers to adhesive wear and transfer of material between metallic surfaces."
Frighten might mean Fretting, "Fretting refers to wear and sometimes corrosion damage at the asperities of contact surfaces. This damage is induced under load and in the presence of repeated relative surface motion, as induced for example by vibration." All definitions from Wikipedia.
I'm say the wear is probably galling, but in any case, Oldfeller might have the answer. No, don't add a ZDDP additive to oil. Buy better oil. The latest gasoline engine oil standard, ILSAC GF-4 has the phosphorus reduced to a max of 0.8% to reduce phosphorus poisoning of the catalytic converter. Diesel engine oil can have up to 1.2% phosphorus, which comes from the zinc dialkyldithiophosphate or related antiwear compounds he mentions. (The upcoming spec, GF-5, will retain the 0.8% P, but further reduce P getting to the catcon by requiring reduced volatility of the oil.) ZDDP is a very effective anti wear and antioxidation agent, and very cheap. Other chemicals work as well but cost more for the blender to put into the oil.
As Oldfeller says, use a dual-rated diesel & gasoline engine oil or a motorcycle oil. Shell's Rotella-T line, either conventional or synthetic is perfectly OK and nothing special. Among conventional 15W-40 oils, Conoco/Phillips/76/Kendall's new diesel/gasoline engine oil with their "Liquid Titanium" is the best of the bunch currently. The standard engine tests for valve train wear show less wear with this oil and actual deposition of titanium on parts. Nothing will rebuild the worn parts, but better oil might slow additional wear.
In any case, if you don't want to replace the parts, I'd hand-stone any high rough areas smooth very carefully with a very fine sharpening stone, clean all the grit away thoroughly, then keep running the engine with more robust oil than a 10W-40.
|