Home
Forum
Search
Login
Register
Merch
Donate
Welcome, Guest. Please
Login
or
Register
::
View Members
SuzukiSavage.com
›
General Category
›
Rubber Side Down!
› disabling sidestand switch on a 2006 s40
(Moderators:
verslagen1
,
Dave
,
Serowbot
)
‹
Previous topic
|
Next topic
›
Pages: 1
disabling sidestand switch on a 2006 s40 (Read 125 times)
texsam
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 138
disabling sidestand switch on a 2006 s40
05/01/09 at 14:33:29
my sidestand switch is actin up how exactly step by step do i go about doing this i have some directions but i just need to be xtra sure about what i'm doing
Back to top
IP Logged
Charon
Serious Thumper
Offline
Posts: 1811
Harvard, NE
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #1 -
05/01/09 at 18:45:29
Why don't you just get another switch and fix the problem, instead of bypassing a safety?
Back to top
Eschew obfuscation.
IP Logged
Jay
Serious Thumper
Offline
SuzukiSavage.com
Rocks!
Posts: 1445
Fort Worth, Texas
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #2 -
05/01/09 at 19:03:00
In installing forward controls, I had no choice in the matter of the side stand switch. There are instructs ( I think) on disabling it in the tech section; but what I did was to reroute the apparatus back to the part of the frame reserved for the Cali canister. I then wrapped zip ties around it to hold the plunger in, and then wrapped the whole mess in duct tape, and secured it to the part of the bike where the canister would sit with more zip ties. The reason I did this instead of snipping the wires was in case the forward controls didn't work out, or I ever wanted to return the bike to stock. I fully intended to go back and make the change permanent; but 5,000 miles plus later, I've frankly forgotten about the thing, and have never bothered to make the disabling permanent.
Back to top
You're invisible and naked.
Ride safe,
Jay
IP Logged
T Mack 1 - FSO
Serious Thumper
Alliance Member
Offline
sold 2001 LS650 for
a 1986 XLH1100
Posts: 2919
Emmaus,Pa
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #3 -
05/01/09 at 19:41:24
On a '06, it's probably not the switch. More likely a wire issue. Unless you have a "flood" bike. Or if you're missing one of the springs.
But, the way the switch works:
.... sidestand up, switch makes contact (closes), allows bike to run when not in neutral.
.... sidestand down, switch opens the contacts. Bike will only run in neutral.
Now.... get you high school science book out and read the chapter on electricity....
Also, when I installedmy Ed L.'s I added lenght to the SS switch wire.
Back to top
Engineers design things, Technicians make them work.
---
30% of being mechanical is confidence/30% is knowing to go slow when needed/30% is looking repeatedly at what you have/10% is dumb luck
IP Logged
prechermike
Serious Thumper
Alliance Member
Offline
Kalashna Kitty, from
Skat
Posts: 1190
Ponzer, NC
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #4 -
05/02/09 at 11:08:30
I too added a little wire to keep the switch in place. I figure I make enough dumb mistakes without asking for one.
Back to top
2006, HD pipe, Tkat fork brace, elkhide handgrips, gel seat w/riser, silverblue, Ed L's forward controls, Wristwatch, biblethumper650@gmail.com
IP Logged
texsam
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 138
Re: disabling sidestand switch on a 2006 s40
Reply #5 -
05/02/09 at 11:20:12
did you judt extend the wire by cutting and twisting together?????
Back to top
IP Logged
texsam
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 138
Re: disabling sidestand switch on a 2006 s40
Reply #6 -
05/02/09 at 11:22:22
do i have to take the whole kickstand assmbley off to get to the switch??????or willl an offset wrench work around that
Back to top
IP Logged
verslagen1
YaBB Moderator
ModSquad
Offline
Where there's a
will, I want to be
in it.
Posts: 28884
L.A. California
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #7 -
05/02/09 at 11:38:05
Only 3 bolts, take 'em off.
Back to top
Versey's Place
Tech Section Index
IP Logged
T Mack 1 - FSO
Serious Thumper
Alliance Member
Offline
sold 2001 LS650 for
a 1986 XLH1100
Posts: 2919
Emmaus,Pa
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #8 -
05/02/09 at 13:54:26
texsam wrote
on 05/02/09 at 11:20:12:
did you just extend the wire by cutting and twisting together?????
Always solder the wires. Twisting the wires together will later be the headache you don't want. Use heat-shrink tubing too. Do it right, you'll be happier in the long run.
texsam wrote
on 05/02/09 at 11:22:22:
do i have to take the whole kickstand assmbley off to get to the switch??????or willl an offset wrench work around that
The switch is held in place by two screws (or was it three.....
). Crawl under and look . I seem to remember that it is a funny angle and you might be able to get it out but .... maybe not.
Back to top
Engineers design things, Technicians make them work.
---
30% of being mechanical is confidence/30% is knowing to go slow when needed/30% is looking repeatedly at what you have/10% is dumb luck
IP Logged
texsam
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 138
Re: disabling sidestand switch on a 2006 s40
Reply #9 -
05/02/09 at 14:18:25
yeah it is 2 and that is kinda what i was thinking it will be a miracle to get them out....maybe an offset wrench will grab it
Back to top
IP Logged
texsam
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 138
Re: disabling sidestand switch on a 2006 s40
Reply #10 -
05/02/09 at 14:21:17
the thing is i don't even know if it is the switch i'm thinking of letting the dealership diagnose it....and i'll put it together its like 80 bucks but i know electrical is a headache and kinda a guessing game but i'm scared if i take it in it won't act up and they will just take money and i'll be sol
Back to top
IP Logged
T Mack 1 - FSO
Serious Thumper
Alliance Member
Offline
sold 2001 LS650 for
a 1986 XLH1100
Posts: 2919
Emmaus,Pa
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #11 -
05/02/09 at 14:24:24
texsam wrote
on 05/02/09 at 14:21:17:
the thing is i don't even know if it is the switch i'm thinking of letting the dealership diagnose it....and i'll put it together its like 80 bucks but i know electrical is a headache and kinda a guessing game but i'm scared if i take it in it won't act up and they will just take money and i'll be sol
Short out the connector under the seat to do a diagnosictic run. Make use you tape up waht ever you use to short it out. Don't want it falling out or touchingsome piece of metal.
Back to top
Engineers design things, Technicians make them work.
---
30% of being mechanical is confidence/30% is knowing to go slow when needed/30% is looking repeatedly at what you have/10% is dumb luck
IP Logged
prechermike
Serious Thumper
Alliance Member
Offline
Kalashna Kitty, from
Skat
Posts: 1190
Ponzer, NC
Gender:
Re: disabling sidestand switch on a 2006 s40
Reply #12 -
05/02/09 at 15:04:16
[quote author=0871113D3F376D5C0 link=1241213610/0#8 date=1241297666]
texsam wrote
on 05/02/09 at 11:20:12:
did you just extend the wire by cutting and twisting together?????
Always solder the wires. Twisting the wires together will later be the headache you don't want. Use heat-shrink tubing too. Do it right, you'll be happier in the long run.
TMack beat me to the punch. That is what I did, solder and heat shrink tubes. I was adding Ed L's forward controls, I did not remove the switch, just cut the wires.
Back to top
2006, HD pipe, Tkat fork brace, elkhide handgrips, gel seat w/riser, silverblue, Ed L's forward controls, Wristwatch, biblethumper650@gmail.com
IP Logged
texsam
Full Member
Offline
SuzukiSavage.com
Rocks!
Posts: 138
Re: disabling sidestand switch on a 2006 s40
Reply #13 -
05/03/09 at 04:50:07
well doing diagnoststic run i shorted it out let it run for 2 or 3 weeks if it doesn't act up i need to order a new switch just got to wait and see
Back to top
IP Logged
Pages: 1
‹
Previous topic
|
Next topic
›
Forum Jump »
» 10 most recent posts
» 10 most recent topics
General Category
»» Rubber Side Down!
- Technical Documents/Reference
- The Marketplace
- The Cafe
- Politics, Religion (Tall Table)
- Forum Upgrade Issues / Tests
« Home
« Home
SuzukiSavage.com
09/24/24 at 03:26:41
›
General Category
›
Rubber Side Down!
› disabling sidestand switch on a 2006 s40
SuzukiSavage.com
» Powered by
YaBB 2.2
!
YaBB
© 2000-2007. All Rights Reserved.