SuzukiSavage.com - problem with cyclinder head nuts

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › problem with cyclinder head nuts

(Moderators: verslagen1, Dave, Serowbot)

Pages: 1

problem with cyclinder head nuts (Read 51 times)

DocNeedles Senior Member Offline I love YaBB 1G - SP1! Posts: 272 British Columbia Gender:	problem with cyclinder head nuts 04/26/09 at 19:07:59 The Suzuki Manual on page 2-4 refers to the cylinder head nuts as being 9 mm and 8 mm. Mine are 14 mm and 12 mm. It is a 1986 any suggestions on why the difference? Thanks. DocNeedles
Back to top	IP Logged

Charon Serious Thumper Offline Posts: 1811 Harvard, NE Gender:	Re: problem with cyclinder head nuts Reply #1 - 04/26/09 at 19:12:04 The size referred to in the books is the size (diameter) of the bolt itself, not the size wrench needed to turn it. The wrench size is bigger.
Back to top	Eschew obfuscation. IP Logged

Yonuh Adisi FSO Serious Thumper Offline Savage Jedi (Knight) Posts: 3622 Pilot Valley NV, aka Tatooine Gender:	Re: problem with cyclinder head nuts Reply #2 - 04/26/09 at 19:46:23 DocNeedles wrote on 04/26/09 at 19:07:59: The Suzuki Manual on page 2-4 refers to the cylinder head nuts as being 9 mm and 8 mm. Mine are 14 mm and 12 mm. It is a 1986 any suggestions on why the difference? Thanks. DocNeedles That threw me also until the guys here explained it to me.
Back to top	Check out Flight of Destiny http://www.amazon.com/dp/B00H9130XC IP Logged

DocNeedles Senior Member Offline I love YaBB 1G - SP1! Posts: 272 British Columbia Gender:	Re: problem with cyclinder head nuts Reply #3 - 04/26/09 at 21:13:39 Charon wrote on 04/26/09 at 19:12:04: The size referred to in the books is the size (diameter) of the bolt itself, not the size wrench needed to turn it. The wrench size is bigger. Hey, Thanks for this, I thought I was going crazy. DocNeedles
Back to top	IP Logged

Pages: 1

« Home