Hey Cory
For future reference, look in the tech section, open the index look for carb stuff it's all together.
1st thing is to know thyself, or where it's currently adjusted.
Turn the screw ClockWise (CW) counting the number of turns till it stops, caution! don't turn it hard! some times it gets stuck.
Turn it CounterCW (CCW) the same number of turns back out.
Start your engine warm it up using any method (stare at it till muffler starts to smoke or my favorite method ride around the neighborhood looking for cats and squirrels to run over, avoiding the dead ones you ran over yesterday)
Now that it's good and warm, get the ear wax out so you can hear real good and slowly turn the screw out untill the rpm drops a bit. This should be done in about 1/8 turn increments waiting abit inbetween, maybe giving the throttle a twist. Repeat until
But keep going until the rpm's start to drop off again.
This can be done on the side of the road inbetween short runs to test it out.
Last word of caution, if the screw is out more than 3 turns, there's a posibility that it can come loose on the road and fall out. If it's more than 3 turns, get the next size up pilot jet.