SuzukiSavage.com - Hello & a question

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Hello & a question

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Hello & a question (Read 2 times)

NW-SAV

Ex Member

Hello & a question
10/02/07 at 11:00:11

First off - Hello everyone - this is an awsome site, I have had my S40 for about 3months and this site was one of the deciding factors in buying it.
I do have question, I have a 07, it has a dyna muffler, side mounted UNI filter, 152.5 main, 55 pilot and about 1/2 white spacer. IT IS MUCH FASTER NOW, but when I roll the throttle wide open, it hesitates for a second and than kinda surges. It does not do it when you slowly roll the throttle open, just when you nail it. I rejetted when I put the new filter on and that is when the this started, I checked the jets and they do not appear to be block or dirty.
thnks

IP Logged

grandpa Senior Member Offline Old but not cold!!! Posts: 259 Bartlett TN Gender:	Re: Hello & a question Reply #1 - 10/02/07 at 11:10:52 Was your vacuum needle and slide spotless when you put it back together?? Sounds like it might be sticking a little.
Back to top	Blue '06, seat mod, K&N drop-in filter, desnorkeled, 55 pilot, 152.5 main, 1/3 spacer, dyna muff, factory bug shield, 11.5 Progressive rear shocks, debadged, fork boots, 110/90-19, 140/90-15 IP Logged

Savage_Greg Serious Thumper Alliance Member Offline Don't go around your ass to reach your elbow... Posts: 7844 SW Washington State Gender:	Re: Hello & a question Reply #2 - 10/02/07 at 11:55:14 I think a little rich. How does your plug look? How about the exhaust outlet?
Back to top	IP Logged

vtail Senior Member Offline life's short, ride fast Posts: 408 Portland,OR Gender:	Re: Hello & a question Reply #3 - 10/02/07 at 12:56:04 Also got an '07 with Mac exhaust,152,5 main 55 pilot,K&N drop-in also in PDX. Did you put the carb slide spring back in (it'll run without) and the plate with the little holes (inside the slide, attached with 2 screws) is put in correctly?
Back to top	'07, White spacer REMOVED, 152,5 main jet, K&N drop-in filter, Mac exh, Sigma 906, ENM PT15B2 tach, factory s bags, shield, backrest/lug rack, crashbar, Kuryakyn 7980 ext hwy pegs,412-4233C+'09 C50T IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home