SuzukiSavage.com - Adjusting spline at the transmission

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › Adjusting spline at the transmission

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Adjusting spline at the transmission (Read 10 times)

forrest Serious Thumper Offline No matter where you go, there you are. Posts: 986 Kennesaw, Ga Gender:	Adjusting spline at the transmission 09/01/07 at 17:12:30 In a thread in the Cafe it was mentioned to adjust the spline at the transmission to raise the shifter a couple of notches. How this this done?
Back to top	Where are we going? And why are we in this handbasket? IP Logged

Max_Morley Serious Thumper Offline LT650 Luxury Touring & sidecar rig Posts: 1490 Moses Lake. WA Gender:	Re: Adjusting spline at the transmission Reply #1 - 09/01/07 at 17:20:31 Well that is the old way. On the Savage there is a turn buckle between the shift lever and shift shaft. Loosen the lock nuts (one is RH thread and the other LH -look to see which is which) and if you make the turnbuckle longer it will raise the pedal tab. Max
Back to top	Max at Thumper Acres. '96 Savage bagger, '03 Savage w/Cozy sidecar for wifeni. IP Logged

Demin

Serious Thumper

Offline

We need more
chlorine in the gene
pool

Posts: 2435
Warren,Ohio
Gender: male

Re: Adjusting spline at the transmission
Reply #2 - 09/01/07 at 17:22:28

If you look where your shift shaft comes out of the motor it has a splined shaft,on yhat there is a splined arm.Take a sharpie and mark across both pieces,then there is a small pinch bolt remove it slide the arm off of the shaft(may take a little work).Move the arm clock- wise to raise it.Counterclockwise to lower it.Probably just a tooth or 2 either way

Next project:finish '87 Savage custom/bobber/CHOP STYLE***DONE
finish '77 Yamaha XS650 bobber Bought another one
finish'79 Harley custom bobber(NEXT)

IP Logged

forrest Serious Thumper Offline No matter where you go, there you are. Posts: 986 Kennesaw, Ga Gender:	Re: Adjusting spline at the transmission Reply #3 - 09/01/07 at 17:25:03 Thanks, I'll try it tommorow.
Back to top	Where are we going? And why are we in this handbasket? IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home