Max_Morley wrote on 12/31/69 at 16:00:04:Just reinforcing it for the new folks. Using the phillips for the punch on carb screws is the only way, otherwise the cross head part will be un-usable and plans C-E have to be tried. The ACR really works, I don't buy anything else now. Come in both loosen, tighten or both ways options. I get both. However once it slips it is option time as it really chews up the screwhead. I also use a hand held impact driver 3/8 drive for the case screws with a APEX brand 1 - 3/4" long bit. Save lots of grief on those. Max
I had a hand impactor once! Think that I sold it at a "Poor Man's Yardsale"
Yeah, I had to use a small cold chisel on one of Stinger's the other day. Didin't mess up the slots. Just left a little blemish on the edge of the head....
I had taken some stainless allen bolts over there but they were too long, and we had no way to shorten them either...no grinder, side grinder, hack saw, band saw, cutting torch, milling machine, EDM or lathe. Oh well. Back in they went