LesGolden
Full Member
Offline
Just a thumpin' away at life.
Posts: 113
Coastal GA
Gender:
|
Ok guys, just got off the phone with Ross, really helpfull people by the way, and heres the skinny. Pins, rings, and pistons would be about 550 for 4. The motorcycle tech said we probably wouldn't notice a difference with skirt milling and there is decreased life with that. Coatings would raise the price a bit and again weren't recommended, he said he'd be happy to sell it too us, but unless we're pounding them with nitrous not really necessary. Bore size doesn't change price, they do all have to be the same piston, and if we have 20 or more the price will drop quite a bit. The compression could maybe get even higher than the 10-10.5 we were talking about, it's dependent on the clearance. If the 8mm deck height is accurate, we could go quite a bit higher. Still though, my vote is for 97mm with just over 10:1 compression, the price is roughly 137.50 each, this is supposed to be a high estimate the actuall cost may be lower.
97mm 10:1 or higher compression. Need at least 2 more people.
|