SuzukiSavage.com - riser spacer for drag bars

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › riser spacer for drag bars

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

riser spacer for drag bars (Read 5 times)

amcline

Ex Member

riser spacer for drag bars
03/03/07 at 19:30:35

hey guys, just wanted to update, with the install of my 4" pullback drag bars (25" or so) the stock mounts let the controls hit the tank, so i got 2" longer grade8 bolts, and hardware, used a 3/8 by 1.5" steel spacer and a 3/4" by 1.5" chrome spacer (for looks) and some rubber washers to prevent any chatter, rises it just enough to clear, and cost les then 20 bux all from home depot, the link to pics is:
http://xdreamz.sslpowered.com/pictures/bike/bike1.htm

will post them now.
the alternative was 6" riser for 30 bux, wich were not chrome so i went this way for my taste of low and chrome. a 2" spacers would clear better but i didnt want to stack or anything. and 1.5" was all this HDepot had...

IP Logged

PerrydaSavage Serious Thumper Alliance Member Offline Riding "The Rock"! Posts: 3522 Republic of Newfoundland Gender:	Re: riser spacer for drag bars Reply #1 - 03/04/07 at 03:08:41 Cool job amcline! 8) Read somewhere of someone using deep-well sockets as you did with the spacers to pop the stock pull-back bar clamps up higher for the drag bar mod ...
Back to top	Before you diagnose yourself with depression or low self-esteem, first make sure you are not, in fact, just surrounded by arseholes! IP Logged

amcline Ex Member	Re: riser spacer for drag bars Reply #2 - 03/04/07 at 12:10:48 thats a good idea actually, i may look around if i can find some a little taller, i have another 1/2" worth of bolt, and the xtra 1/2" would make clearing the tank a bit better,
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home