LANCER
Serious Thumper Alliance Member
Offline
Savage Beast Performance Parts
Posts: 10689
Oklahoma
Gender:
|
Yep ... black smoke = VERY RICH
Try this: take the filter off and remove the plates on the muffler. This way it is completely open on both ends and can get as much air in and exhaust out as possible.
Clean the plug before starting it again.
Does that help? Check the plug again and see what it looks like. Any more black smoke?
If this gets it to a lean enough point then you can start to reverse the process. Put the air filter back on but be sure it is clean and without excess oil.
Check plug again ...black smoke? If it is still lean then start adding the muffler disc's back on, and start with the max number you have and work down.
Do this until the plug reads the best mix.
If it is running too rich for the filter and disc's to be back on then lean the carb by going back down on the jet sizes. Black smoke at anything less than 3/4 throttle would indicate a reduction in the pilot jet, 1 size at a time, and readjust the pilot air adjusting screw.
For the main jet, with the engine warmed up, run it wide open in 3rd or 4th, and if it runs good then go up 1 size, and continue to go up until it begins to bog down when wide open. At that point, go back down 1 size main jet...that is the one you want.
Is that helpful?
|