The catseye taillight was a Christmas Gift, might have come from
Accessory International.Remove saddlebags and seats. License light is held on with a pair of 3/8" nuts, pulled, disconnect the two bullet connectors under the pillion and pull out the wires. The new taillight bolted right in the existing holes, with the addition of a couple of flat washers. Also added a ground wire under one of the nuts, using a ring connector, altho' it is not actually necessary. Taillight is held with three 10mm bolts, pulled, cut the wires near the bulb. Put bullet receptacles on the ends of the wires, matching bullet connectors on the wires from the new taillight. Plug together, dress up the wires. Replace seat & bags. Done. Just have a few holes in the fender that need a little bondo and paint.