Here is my idea for a remote oil filter hookup, been working on it for a couple of days and think this will work. Take a round chunk of aluminium or brass a little smaller in diameter than the stock oil filter and turn one end down to fit in the engine where the tip of the filter with the "O" ring sits. Run a large hole thru that end about 3/4 of the way into the piece of metal.
Drill and tap a hole into the side of the adapter so it meet the large hole. Run a line from the side hole in the adapter out thru the side of the oil filter cover using compression fittings and a short piece of brake tubing. For the second line just drill and tap a second hole in the top edge of the oil filter cover and install whatever fitting you are using.
This design replaces the oil filter with an adapter that runs all the oil out thru the side of the oil filter cover to an external filter and cooler and returns it to the engine.
I don't think it would be hard to machine up the adapter, already found a round chunk of brass that should do the trick. I'm just trying to figure out which way the oil flows, out of the cover into the filter or out of the filter into the cover, anybody out there know offhand?. What do you all think, will it work or not?
The next couple days I'll be looking for fittings and and stuff for the mod, if it comes together I'll take pictures for everybody.
, This is a itch that needs scratching.