SuzukiSavage.com - bolt torque

Donate!

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › bolt torque

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

bolt torque (Read 3 times)

klinc Ex Member	bolt torque 05/10/06 at 06:41:52 Hi, I am trying to replace the gasket on the stator/starter gear cover but everytime I put the cover on I seem to overtighten the bolts causing oil to leak and having to get another gasket. Can anyone tell me what the bolts on the cover should be torqued to or any special instruction for getting this thing on without causing a leak? Thanks
Back to top	IP Logged

torque Serious Thumper 2005 No Login Offline 2008 nightster,flat od green and black Posts: 748 rock hill,S.C. Gender:	Re: bolt torque Reply #1 - 05/10/06 at 07:27:06 only snug them up, dont even use a torque wrench,a 1/4 inch drive socket will be enough for them. put some gasket sealer on the backside of the gasket so it stays in place while u tighten the bolts.put the cover on then before u tighten the cover look at the gasket to see if it's still in place,if it is tighten the bolts.
Back to top	IP Logged

klinc Ex Member	Re: bolt torque Reply #2 - 05/10/06 at 10:04:26 Thanks for the reply. Will try to go easy on them tonight when I get to it.
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

« Home