SuzukiSavage.com - cam timing

Welcome, Guest. Please Login or Register :: View Members

SuzukiSavage.com › General Category › Rubber Side Down! › cam timing

(Moderators: verslagen1, Dave, Serowbot)

‹ Previous topic | Next topic ›

Pages: 1

cam timing (Read 2 times)

clayton Ex Member	cam timing 03/31/06 at 20:24:54 I need help aligning the cam sprocket on my 650, I figured out how to get the piston at TDC but I need to know where to point the mark on the cam. Thanks, Clayton
Back to top	IP Logged

Kropatchek

Serious Thumper

Offline

Why more than 1
cylinder?

Posts: 1457
Alphen a/d Rijn Netherlands
Gender: male

Re: cam timing
Reply #1 - 04/01/06 at 02:58:12

Clayton wrote on 12/31/69 at 16:00:03:

I need help aligning the cam sprocket on my 650, I figured out how to get the piston at TDC but I need to know where to point the mark on the cam.

Thanks,
Clayton

Keep the engine at TDC.
There's a line enscribed on the camshaft, keep this in line with the head. This should bring the 2 boltholes and the alignment pin in line with the camgear. Position the locking washer and the 2 bolts, tighten up. Turn the crankshaft clockwise ( remember you're looking at the RH side of the engine) 2 full revolutions.
Check the alignment of the cam again. Torque the 2 bolts 10 to 11.5 lb-ft, bent the locking tabs over and you're done.

Good luck
Greetz
Kropatchek Grin

Never ask your bike to scream before her throat is warm.
'93 Sav in '96 ( yellow) looks

IP Logged

slavy Serious Thumper Offline smart cars for stupid people Posts: 710 Phoenix, Arizona Gender:	Re: cam timing Reply #2 - 04/01/06 at 06:49:18 And don't You think, it will be good to buy a shop manual and read it if You want to do some real work ?
Back to top	The arificial intelligence is no match for the natural stupidity IP Logged

Kropatchek Serious Thumper Offline Why more than 1 cylinder? Posts: 1457 Alphen a/d Rijn Netherlands Gender:	Re: cam timing Reply #3 - 04/02/06 at 04:54:23 slavy wrote on 12/31/69 at 16:00:04: And don't You think, it will be good to buy a shop manual and read it if You want to do some real work ? Why did't I give him that advice? Greetz Kropatchek
Back to top	Never ask your bike to scream before her throat is warm. '93 Sav in '96 ( yellow) looks IP Logged

clayton Ex Member	Re: cam timing Reply #4 - 04/02/06 at 17:32:01 Quote: And don't You think, it will be good to buy a shop manual and read it if You want to do some real work ? Isn't that what this place is for, To get help.
Back to top	IP Logged

911radioman Ex Member	Re: cam timing Reply #5 - 04/02/06 at 17:42:36 Clayton wrote on 12/31/69 at 16:00:04: Isn't that what this place is for, To get help. Yes it is, but it doesn't replace one doing some legwork himself either.
Back to top	IP Logged

Pages: 1

‹ Previous topic | Next topic ›

« Home